Welcome to my "VSS Vintorez Conversion"
page. Airsoft Dragunov Base
Basically, this
pattern makes the stringers and side panels that make an AK
into a Vint.
Ingredients:
1 airsoft "Dragunov", clone OK.
1 Cereal box (for making test parts)
1-2 sq. ft. 3mm / 1/8" ABS plastic (for
making actual parts)
2 ft, of 2" ABS
tubing
Determination
A.
FILE OUTPUT SETUP:
Once you are viewing
the pattern page in ACDSee, go to file -print...Print
setup...
Set all "margins (inches)" to
zero. Set "size" to "default".
Under
"Rendering", set "resolution (dpi)" to 300. Click "Save
settings" THIS IS IMPORTANT.
Click
Ok.
B. PRINTER
SETUP:
Go to file - Print...
Make sure your printer is the one
selected.
C:
PRINTING:
Click print. The ACDSee print
window will re-appear. all your previous setting up should
remain, and you will see the pattern previewed in the
window.
Click OK.
NOTES:
YOU MAY HAVE TO CHANGE
PORTRAIT/LANDSCAPE ORIENTATION TO FIT.
The ACTUAL PRINT SIZE is not important,
prints can be slightly off in dimension, as long as ALL prints
are done with the same setup. Parts made will all fit right
up, as any error will be relative to all parts
made.
ASSEMBLY
GUIDES HERE
SPECIAL NOTE: FILES:
AIRSOFTTRIPOD0002
bigmini019
hailforce004
HAVE BEEN ABSORBED INTO OTHER
PAGES' CONTENT.
VSS VINTOREZ RIGHT-CLICK TO
DOWNLOAD OR VIEW
