|
I figured
out how to make a itty, bitty, wee, ittle, miniscule,
microscopic, almost, minigun...
Tearing down an
MP7:
This is just the gearbox itself. You can
get it right out by pulling the pins from the rear of the gun
chassis.
2-inch ABS pipe will be the main body
tube. I made a small cradle to hold the gearbox in position.
It's barely visible here.
Itty-bitty, huh?
Teeny, tiny!
Access hole for adjusting the hopup.
The barrel sits nice and straight now.
The barrel
pack glued up, and the axle in its mount. At this point, the
barrels still need turning on the lathe, and the axle needs to
be permanently anchored.
NEXT
PAGE
I thank you for coming by to visit Killbucket's,
"The best place to spend your boss's
time"!
Share
| Please- feel free to
share this page with a
friend!
|
|
