actual killbuckets minigun drive, taken apart:
HOME M2 M1919 MINIGUN PRIVACY SITEMAP PATTERN SETS
Please- feel free to share this page with
a friend! Por favor, siéntase libre para compartir
esta página con un amigo! Thank you for visiting
my humble 900+ page site. Come on in,
make sure your coffee's freshly topped off. A
handy share button is found on the bottom of most
pages, or just copy the address from the
navigation bar at your page top. This
page links you to my vast toy room, and
you can be here for literally hours and
not see everything. Minigun and Browning
videos and construction plans, airsoft videos and
gun mods, and a whole lot more that's very
unexpected. Please, tell your friends
about at least one page before you
Timken bearing set #2 is used. A Chevy
Colorado truck uses the same part on the front wheels, 2 wheel
drive, by the way. the 3/4 plumbing pipe axle is turned down
slightly for them to fit. It is close enough to use a file;
you may get lucky and find smaller pipe, because its sizes by
the inside diameter, not outside. It can
Using a metal center axle makes for a
tough, solid m134 minigun assembly that can outlive yourself.
However, it's also harder to make, mount, and drive. It also
makes for a lot of the weight in the finished minigun, and
that is important with an airsoft minigun you want to actually
quarter-inch thick ABS sheet and PVC
tubing make up the spade grip yoke for a mounted minigun
airsoft. In the foreground is an assembled barrel pack
, and a delinker assembly.
you can see the RC car drive motor, the metal bushing that is
pressed onto it to extend its motor shaft. The tapered roller
bearings will live forever in an
because they are meant to
The basic parts bonded together to make
the big delinker assembly for the m134 minigun, airsoft
minigun delinker chute looks as if it is flexible, but it is
actually a rigid assembly.
were scraps from the CNC, I'd made some parts for a customer,
and these were the carrier strips for them.
The helix on the side of the main body is
a strip of ABS sheet, softened in the oven, and glued on. An
M134 minigun has helical tracks inside to guide the bolts of
each individual gun inside.
This pattern is not supported in any way,
shape, or form!
Please- feel free to share this page with a
friend! Por favor, siéntase libre para compartir esta
página con un amigo! Thank you for visiting my humble
900+ page site. Please feel free to Bookmark
this site, and come back again when you have more time.